ATTACHING INSTRUCTIONS
 

 

Please Note: Two spanners (13mm) are required to attach Leg Treads
 
             
STEPS:
 
1.    Slide heat shrink over bolt (leaving thread uncovered)        5.    Screw on Nylock nut and tighten until outside of nut is
       and heat over gas burner                                                       level with end of bolt.
2.    Wind stabiliser leg half way                                            6.    Wind stabiliser leg into position.
3.    Position base of stabiliser leg into Leg Tread.                   7.    Repeat steps 1-6 for each stabiliser leg.
4.    Insert bolt through hole in                                               8.    To stop ants, fill each moat with water
       Leg Tread and stabiliser leg                                                  or other suitable substance.


(c)2002 TurfWare Pty Ltd
 
HOME

(c)2002 TurfWare Pty Ltd